- 您现在的位置：买卖IC网 > Sheet目录326 > FL103M (Fairchild Semiconductor)IC PWM CTLR FLYBACK 8-SOIC
is between normal output voltage (V O ) and 50% of
normal output voltage (V O ). The other is 33 kHz. When
drops under 50% of normal voltage (V O ). At that time,
protection. To avoid 33 kHz, V O should be designed
Pulse-by-Pulse Current Limit
When the current sensing voltage (V CS ) across the
current-sense resistor (R Sense ) of MOSFET (Q1)
exceeds the internal threshold of 0.8 V, the MOSFET
(Q1) is turned off for the remainder of switching cycle. In
normal operation, the pulse-by-pulse current limit is not
triggered because the peak current is limited by the
control loop.
Leading-Edge Blanking (LEB)
Each time the power MOSFET (Q1) switches on, a turn-
on spike occurs at the sense resistor (R Sense ). To avoid
premature termination of the switching pulse, a leading-
edge blanking time is built in. Conventional RC filtering
can be omitted. During this blanking period, the current-
limit comparator is disabled and cannot switch off the
gate driver.
Gate Output
The FL103 output stage is a fast totem-pole gate driver.
Cross conduction has been avoided to minimize heat
dissipation, increase efficiency, and enhance reliability.
The output driver is clamped by an internal 15 V Zener
diode to protect power MOSFET transistors against
undesired over-voltage gate signals.
Built-in Slope Compensation
The sensed voltage across the current-sense resistor is
used for Current Mode control and pulse-by-pulse
current limiting. Built-in slope compensation improves
stability and prevents sub-harmonic oscillations due to
peak-current mode control. The FL103 has a
synchronized, positive-slope ramp built-in at each
switching cycle.
Noise Immunity
Noise from the current sense or the control signal can
cause significant pulse-width jitter, particularly in
Continuous-Conduction Mode. While slope
compensation helps alleviate these problems, further
precautions should still be taken. Good placement and
layout practices should be followed. Avoiding long PCB
traces and component leads, locating compensation
and filter components near the FL103, and increasing
the power MOSFET gate resistance are advised.
Operation Area
Figure 24 shows operation area. FL103 has two
switching frequency (f S ) in Constant Current Mode. One
is 50 kHz. In this case, FL103 can be operated with best
condition for LED illumination. The output voltage range
N
N
the output voltage is dropped, by increased load and
decreasing the number of LEDs, the output voltage (V O )
N
V DD drops to near UVLO protection and triggers
N
with enough margin.
? 2012 Fairchild Semiconductor Corporation
Figure 24.
Operation Area
www.fairchildsemi.com
FL103 ? Rev. 1.0.2
12
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
FL6300AMY
IC CTLR PWM QUASI CURR 8-SOIC
FL7701MX
IC LED DRIVER PFC BUCK 8-SOIC
FL7732M_F116
IC LED DRIVER PFC PRIMARY 8-SOIC
FLASHPRO LITE
KIT PROGRAMMER FLASHPRO LITE
FLS2100XS
IC CTLR FPS HALF BRIDG LCC 9-SIP
FMD15.24G
1500W 24V DC-INPUT 48V RECTIFIER
FMP25.48G
2500W 48V AC-INPUT RECTIFIER
FND850-12DRG
FRONT END DC/DC 850W 12V
相关代理商/技术参数
FL1041
制造商:Pulse 功能描述:- Bulk
FL1043
制造商:Pulse 功能描述:10BT FILTER WITH CMC - Bulk 制造商:Pulse Electronics Corporation 功能描述:10BT FILTER WITH CMC
FL1046
制造商:Pulse 功能描述:10BTFILTERWITHCMC - Bulk
FL1046NL
制造商:Pulse 功能描述:10BTFILTERWITHCMC HAZMAT - Bulk
FL1057-002
制造商:Pulse 功能描述:- Bulk
FL1059
制造商:Pulse 功能描述:10BT FILTER WITH CMC&RES - Bulk
FL1065
制造商:Pulse 功能描述:10BT FILTER WITH CMC&RES. - Bulk 制造商:Pulse Electronics Corporation 功能描述:10BT FILTER WITH CMC&RES.
FL1066
功能描述:变压器音频和信号 10BT FILTER WITH CMC
RoHS:否 制造商:Skyworks Solutions, Inc. 频率范围:810 MHz to 960 MHz 初级线圈阻抗: 次级线圈阻抗: 绝缘电压:23 dB 工作温度范围:- 40 C to + 85 C 端接类型:SMD/SMT 尺寸:6 mm L x 4.9 mm W x 1.6 mm H 产品:Splitters and Combiners